Register Now

mrmurder1975 · 12-09-2008, 03:42 PM

hello all. i have a hbfp on 2.4g. its worked fine for weeks but a sudden problem occured last week. it seems my tx will no longer talk to the rx

. the led on the tx will blink on and off at one second intervals constantly instead of the rapid 3 second burst under normal operation and no amount of stick input effects the heli.

a few days after the tx problem occured the rx developed a problem too

it has an orange light blinking. again,at one second intervals, on the 4 in 1. this light is not located on the pot/gain screw side of the 4 in 1 but the opposit side.(status light?) I was just getting good with my hb and am so desperate to get it flying again im climbing the walls!

any help that could be offered would be really appreciated,thanks very much

Dusty1000 · 12-09-2008, 09:09 PM

Hi, at the risk of being too obvious, have you tried new batteries in the TX?

mrmurder1975 · 12-10-2008, 02:24 AM

hey...thanks for the reply mate

i really wish it was the tx batterys! but no,they are fresh.

va3sax · 12-21-2008, 10:36 AM

I would recommend that you try performing the unbinding and rebinding of the receiver as detailed in the manual for the 2.4 GHz system if you haven't already tried that approach

12-09-2008, 03:42 PM	#1 (permalink)
mrmurder1975 Registered Users Join Date: Dec 2008	new to this site and needing help!..please!! hello all. i have a hbfp on 2.4g. its worked fine for weeks but a sudden problem occured last week. it seems my tx will no longer talk to the rx. the led on the tx will blink on and off at one second intervals constantly instead of the rapid 3 second burst under normal operation and no amount of stick input effects the heli. a few days after the tx problem occured the rx developed a problem too it has an orange light blinking. again,at one second intervals, on the 4 in 1. this light is not located on the pot/gain screw side of the 4 in 1 but the opposit side.(status light?) I was just getting good with my hb and am so desperate to get it flying again im climbing the walls! any help that could be offered would be really appreciated,thanks very much

12-09-2008, 09:09 PM	#2 (permalink)
Dusty1000 Registered Users Join Date: Sep 2008	Hi, at the risk of being too obvious, have you tried new batteries in the TX? __________________ Blade 400, mSR, mCPX - Sonix SX450SE - Walkera 1#A, 4#3, 4#3A, 4#3B, 4G3

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-10-2008, 02:24 AM	#3 (permalink)
mrmurder1975 Registered Users Thread Starter Join Date: Dec 2008	hey...thanks for the reply mate i really wish it was the tx batterys! but no,they are fresh.

12-21-2008, 10:36 AM	#4 (permalink)
va3sax My HF Map location Join Date: Sep 2007	I would recommend that you try performing the unbinding and rebinding of the receiver as detailed in the manual for the 2.4 GHz system if you haven't already tried that approach

Register Now

Log-in