Naze32+KV OSD+GPS+Spektrum Sattelite

[xfactor6]

Does anyone have this running? What im having trouble with is the rx pin gets connected to spectrum satellite but the GPS also uses the same. So not sure how this should be hooked up. Can it use the same pin on the board?

[u8mydog]

Take a look at the possible patches.There is one patch that allows you to config a soft uart for gps.

[xpantz]

Originally Posted by u8mydog

Take a look at the possible patches.There is one patch that allows you to config a soft uart for gps.

Yeah I think you would need to do something funky.

Probably easiest to use a CPPM receiver.

and on GPS in general...
I have a couple of APMs and GPS/alt hold/etc works very well.
I have also played with and read a bit about GPS/alt hold/etc on Naze32 and CC Revo... I'd just say that if I really wanted GPS I'd probably use an APM or a Naza

[Subaru4WD]

Yup, you need to enable soft serial. Or just dont use Spek Sat.

[t-mik]

Originally Posted by xfactor6

Does anyone have this running? What im having trouble with is the rx pin gets connected to spectrum satellite but the GPS also uses the same. So not sure how this should be hooked up. Can it use the same pin on the board?

Did you get anywhere with this? I'm heading down the same path in parallel to a PPM build.
If it's possible to do with a SAT, then since that's what I already have soldered to the Naze I'd rather go that way.