yge to vbar adapter wire conector pin

[abrajim]

i am finishing the build of my xxtreme but i came into this question, in the female conector of the adapter wire that came in the kit to conect the yge to the vbar for the governor, i found that the pin that came from the brown cable is bend towards the pin in the center and i don't know if this is intended to be like this so the two pins goes in the same cable in the yge cable or it's simple a bended pin that i have to fix and each pin goes individually in the yge progcard cable???

really confusing because it was so perfectly bend that makes me think it was made that way.

[matrosek]

have a picture ?

[abrajim]

Jan i try to take one like 100 times and i can't get a clear pic of the pins but after i check here http://elektrorc.com/article_info.php?articles_id=2 i think that the pin must go straight, now i don't now if i am using 8.4v for the servos is there any problem with the yge conected to this voltage??

[dahld]

The pins in the plug should be straight.

(-: Dave