Need help with hh brushless

[ikarma]

So I bought a new HH esc and soldered it to the board. Worked great with my motor from previous esc. Last night I soldered in some heaver gauge wires and now the motor does not turn at all.

When I first turn it on my 3n1 looked like it went into bind mode. So I tried to rebind several times... no luck.

I moved the HH esc to another 3n1 I have and I bound it to same model in radio. Turned it on and it made the initialization beeps. Throttle up, motor does not move at all. When I plug in the battery the motor does bump a tiny bit. But I throttle up I get nothing but tail motor.

What should I look for to trouble shoot?

[ikarma]

fixed. Wire broke inside between esc and 3n1 because too much solder flowed inside the casing. Had nearly 90 degree turn in it and ohm meter proved it broke.

Flies great with all upgraded wires and hardwired.