Binding R3 Receiver

[mjohnson]

Hey Guys

I am trying to bind my R3 Receiver and the tx (DC-16) does not see it. It is a new R3 and apparently has 3.11firmware. How do you get this rx to work?? All I see in the tx device explorer is RC Switch. There does not seem to be any literature from Jeti on the R3 operation.

An Update......

Got the R3 to bind to the tx and it shows in device explorer. Now the iKon and rx are not talking to one another. Never simple.......will post this in the iKon thread.

Thanks

MJ

[Bubbasanjohn]

Originally Posted by mjohnson

Hey Guys

I am trying to bind my R3 Receiver and the tx (DC-16) does not see it. It is a new R3 and apparently has 3.11firmware. How do you get this rx to work?? All I see in the tx device explorer is RC Switch. There does not seem to be any literature from Jeti on the R3 operation.

An Update......

Got the R3 to bind to the tx and it shows in device explorer. Now the iKon and rx are not talking to one another. Never simple.......will post this in the iKon thread.

Thanks

MJ

Don't forget to change the receiver output to ppm positive. Then make sure that the link from R3 to ikon is in the right spot on the ikon.