Register Now

Butch Miller · 10-15-2014, 07:45 PM

When I plug the battery into the ECS all the servos initialize except the rudder servo. They are all 1520 us. The zyx-s is set for all 1520us. I installed a new servo. After 3 flights with a lot of tail wag it quit working. I installed it on another receiver and it works fine. I have tried everything but resetting the zyx-s. Any ideas?

jbilliter · 10-15-2014, 07:57 PM

Search the forums. If it is a true zyx-s (not s2) it had a problem with some servos (with me it was eflite servos) I think the solution was downgrade the firmware or upgrade it to the newest.

10-15-2014, 07:45 PM	#1 (permalink)
Butch Miller Registered Users Join Date: Sep 2012	ZYX-S tail servo won't initialize When I plug the battery into the ECS all the servos initialize except the rudder servo. They are all 1520 us. The zyx-s is set for all 1520us. I installed a new servo. After 3 flights with a lot of tail wag it quit working. I installed it on another receiver and it works fine. I have tried everything but resetting the zyx-s. Any ideas? __________________ Helidork

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-15-2014, 07:57 PM	#2 (permalink)
jbilliter Registered Users Join Date: Feb 2012	Search the forums. If it is a true zyx-s (not s2) it had a problem with some servos (with me it was eflite servos) I think the solution was downgrade the firmware or upgrade it to the newest.

Register Now

Log-in