gryphon vega wiring to 3gx

[size zero weasel]

Hi all

I'm getting some weird servo twitching on my 600e pro dfc. I have a gryphon vega powering the electronics but I am only using one of the output cables from the gryphon to supply the 3gx. The 3gx is wired to two dsmx sats, frame rate 11ms and im sure im getting a volt drop on the gryphon. Do I need to connect both the power cables from the gryphon to the 3gx if so where to. The 3gx is v4.

Thanks in advance for any help.

[size zero weasel]

Hi mate just finally got to the bottom of the funny servo movements. It was voltage sag from the vega. The 3gx looks like it can only be powered from one port but it can be powered via the battery out port as well as the normal power port. This version of software must be so power hungry its mad. With the vega only connected to one port on the 3gx it was pulling so much load it was dropping the voltage from the vega. Now both leads are connected to the 3gx it sounds totally different even the lights on the 3gx and the sats seem brighter. I think I'll rebind and do all the dir again tomorrow.