Exi 450 and Futaba 7c receiver setup for a newbie

[mistercrews]

Greetings,

After finally getting around to getting the time to setup my Exi 450 with a Futaba 7c tx/rx I'm running into some configuration issues. Being used to planes only this is a little new to me. Would any of the better users out there be able to tell me the proper RX setup configuration or have a guide? The guide in the Futaba manual is less than useful (or I'm just an *****), everywhere else I've looked at what channel to plug what servo, esc and gyro in doesn't seem to work . Would GREATLY appreciate any info. I'd like to see her fly after so long.

Kind Regards,

~Mistercrews

[salrica]

Originally Posted by mistercrews

Greetings,

After finally getting around to getting the time to setup my Exi 450 with a Futaba 7c tx/rx I'm running into some configuration issues. Being used to planes only this is a little new to me. Would any of the better users out there be able to tell me the proper RX setup configuration or have a guide? The guide in the Futaba manual is less than useful (or I'm just an *****), everywhere else I've looked at what channel to plug what servo, esc and gyro in doesn't seem to work . Would GREATLY appreciate any info. I'd like to see her fly after so long.

Kind Regards,

~Mistercrews

Go to Parameter choose type HR3 for helis.
Then Channel 1 Aileron
2Elev, 3Throttle (ESC) 0, 4 Rudder 0, 5 Gyro 0, 6 Pitch servo, 7 aux at 0
Servo (-) lead goes outside the receiver body
Here is a Link for that radio used on a 450se from Finless Bob https://www.helifreak.com/showthread.php?t=11373
Go to CCPM set up step