tail belt not ligning up right

[Corvette & Copter Guy]

I posted this in the 300cfx but think there is more traffic here. I installed a new main shaft and aluminum hub with aluminum tail drive gear. When installed the tail drive gear sits lower than the tail belt pulleys. The little brass washer is below the hub (above the lower bearing block). Am I missing something?

[Papa Tom]

Cn you post a picture, I can't get a mental picture.

[Corvette & Copter Guy]

I posted a pic in the 300CFX section.

[Leyline]

Well you should post it again here. Or link to it. If you are asking for help, don't make people work to go find the other post somewhere. Gives them more time to help with your problem. And more people might see it.

[vtown nick]

https://www.helifreak.com/showpost.p...39&postcount=5

[ahahn]

You don't have to download the picture again, just copy the link address and paste it in using the image icon above.

But getting t your problem, I think these are just the aftermarket parts not being compatible, or a combination of slightly incompatible parts.

[vtown nick]

Lynx slant main gear and one way is a very good fit and so quiet!!