SD-10G MicreaBeast set up

[RBoyne]

Looking for help with my setup endpoints limits on my SD-10.
The beast seems to be working all direction but having too much cyclic.

[Mark Dean]

Hello ,
When you say too much cyclic are you referring to binding? The best way to set up is to leave your endpoints at default. Adjust the cyclic and collective pitch limits with the beastx setup. Set up dual rates on the sd-10g and set them to about 60% to start out. Then adjust the rates to your liking.


Mark

[TMoore]

Originally Posted by RBoyne

Looking for help with my setup endpoints limits on my SD-10.
The beast seems to be working all direction but having too much cyclic.

Have you checked your email? I emailed you several days ago and never heard back. I would be more than happy to help.

TM

[RBoyne]

Originally Posted by TMoore

Have you checked your email? I emailed you several days ago and never heard back. I would be more than happy to help.

TM

I didn't see any mail.
I wash wondering about my aileron and elevator setting. I read and seen several ways of set up and was just asking.
I set my pitch @10+ 11- on 1,2 and 10+ 6- N
Ailerons are about 13 off my scale.
Setting DR I had go go down to 20% to keep within 8
After bringing travel down I noticed operation was much slower.

[Mark Dean]

I don't believe that you are setting the beastx up properly.With all of your radio settings at default values for end points and no D/R you should adjust the beastx to achieve the cyclic and collective pitch values that you require by using the rudder stick in steps K and L.. Ensure that you exit all the way out of the beastx menu after you complete those settings.

[TMoore]

Originally Posted by RBoyne

I didn't see any mail.
I wash wondering about my aileron and elevator setting. I read and seen several ways of set up and was just asking.
I set my pitch @10+ 11- on 1,2 and 10+ 6- N
Ailerons are about 13 off my scale.
Setting DR I had go go down to 20% to keep within 8
After bringing travel down I noticed operation was much slower.

Bringing the travel down on the TX will equal slow input to the Beast. I have two perfected setups that I can send you if you have a cable to transfer the setups to your TX.

You're setup is way off and that's why the Beast is acting the way it is.

TM

[LAMAR COOLEY]

Hello TMoore
Randy and I had been discussing his BeastX issues over the phone for a couple of weeks. We finally got together this past weekend at a local Fly-In.
Upon reviewing his setup, He had setup and parameter issues. Looks like we have sorted this out. He has informed me that all seems well.

[RBoyne]

Thanks TM,
I sent you a PM

[RBoyne]

Thanks T Moore,
I sent you a PM yesterday.

[TMoore]

Originally Posted by LAMAR COOLEY

Hello TMoore
Randy and I had been discussing his BeastX issues over the phone for a couple of weeks. We finally got together this past weekend at a local Fly-In.
Upon reviewing his setup, He had setup and parameter issues. Looks like we have sorted this out. He has informed me that all seems well.

Very good Lamar. Thank you.

TM

[WillJames]

Thanks Terry!!! You rock man. Thank you for helping your heli brothers like you always have!