START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Flybarless Helicopter Systems CSM Cyclock, Helitronix Multi-mixer, Spartan AP2000i, Firmtronix Digimix-3, Gyrobot, SK360and AC3X |
|
LinkBack | Thread Tools | Display Modes |
10-12-2014, 12:15 PM | #1 (permalink) |
Registered Users
Join Date: Aug 2008
|
copterx-3x2000 gyro
What do the 2 cyclic pots on the unit actually do?Adjusting them does nothing to the values when using the cx-pb001 box.Which parameter when adjusted will give more of a flybar effect.I've just about given up with this unit and I'm thinking of converting this copterx600e to flybar.Trying to hover is a nightmare,it's more like desperate attempts to avoid a crash.It's so touchy even with 80% expo.
|
Sponsored Links | |||
Advertisement |
|
12-10-2014, 09:35 PM | #2 (permalink) |
Registered Users
Join Date: Mar 2013
|
I have figured this one out.
Pot 1 - Tail gyro sensitivity. (Overridden by TX on channel 5) - visible in the software and should be by any programmer. Pot 2 and 3 - Elevator and Roll gyro sensitivity. (NOT AFFECTED by radio or software settings.) So, ch 5 below middle is blue light, rate mode on all three axis, and above middle is heading hold plus adjusts tail sensitivity. I am struggling with a 250 now to find the sweet spot on these pots. In my case it is somewhere near the middle. |
12-12-2014, 06:49 PM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: Aug 2008
|
Thanks for that.I don't think this gyro is any good for a large heli.I've bought a TGZ380 gyro to see if there's any difference(it's a beastx copy).If it's any good i'll buy the 6axis microbeastplus.My wltoys v977 is more stable than this copterx600.
|
Thread Tools | |
Display Modes | |
|
|