copterx-3x2000 gyro

[helibeli]

What do the 2 cyclic pots on the unit actually do?Adjusting them does nothing to the values when using the cx-pb001 box.Which parameter when adjusted will give more of a flybar effect.I've just about given up with this unit and I'm thinking of converting this copterx600e to flybar.Trying to hover is a nightmare,it's more like desperate attempts to avoid a crash.It's so touchy even with 80% expo.

[gunny_jeeves]

I have figured this one out.

Pot 1 - Tail gyro sensitivity. (Overridden by TX on channel 5) - visible in the software and should be by any programmer.
Pot 2 and 3 - Elevator and Roll gyro sensitivity. (NOT AFFECTED by radio or software settings.)

So, ch 5 below middle is blue light, rate mode on all three axis, and above middle is heading hold plus adjusts tail sensitivity.

I am struggling with a 250 now to find the sweet spot on these pots. In my case it is somewhere near the middle.

[helibeli]

Thanks for that.I don't think this gyro is any good for a large heli.I've bought a TGZ380 gyro to see if there's any difference(it's a beastx copy).If it's any good i'll buy the 6axis microbeastplus.My wltoys v977 is more stable than this copterx600.