LOGO 600SX

[mahbouni]

Originally Posted by itsparks

what's this slave lead all about ?

The Jive BEC is rated at 15A peak. One servo lead is not enough to carry all that current. The master lead carries the throttle signal but the slave lead shares the load.

[Mr.Gobler]

Originally Posted by mahbouni

The Jive BEC is rated at 15A peak. One servo lead is not enough to carry all that current. The master lead carries the throttle signal but the slave lead shares the load.

is that built into the esc ? is it a cable i need tobuy that plugs into the vbar ? ( on a free port )

Sorry for all the questions..

[GimpyGolden]

Originally Posted by itsparks

what's this slave lead all about ?

Like two hoses will flow more water two BEC leads will flow more current.
Here it is
http://www.readyheli.com/9250-Kontro...g_p_32120.html

[GimpyGolden]

Originally Posted by itsparks

is that built into the esc ? is it a cable i need tobuy that plugs into the vbar ? ( on a free port )

Sorry for all the questions..

Jive has a port for it but cable is sold separately.
Plug in to spare port on V-Bar or Rx or if all are full use a Y connector on one port.

[mahbouni]

Originally Posted by itsparks

is that built into the esc ? is it a cable i need tobuy that plugs into the vbar ? ( on a free port )

Sorry for all the questions..

Jive 80HV comes with one cable. You need to buy a second one like GimplyGolden linked to. If you have a MiniVbar the master goes into RxB and the slave goes into RxC. Do NOT connect any power source to RxA.

[EEngineer]

You might also consider the Kontronik heat sink for your Jive 80 HV...


http://www.readyheli.com/9470-Kontro...k_p_32123.html

FWIW

[Mr.Gobler]

Originally Posted by EEngineer

You might also consider the Kontronik heat sink for your Jive 80 HV...


http://www.readyheli.com/9470-Kontro...k_p_32123.html

FWIW

I got boxes of heatsinks ill use one of my own, those on that link are literally 25 cents. Lol


Thanks for the link for the cable, will grab one of those when I order..