Register Now

helis101 · 08-10-2006, 03:05 AM

I have the new rex 600 i was wondering i can run s9252 for cyclic on 6volts? Will the bec witch has an 5.9 volt out put work for these servos or will i fry the servos? or do i have to get 6volt regulators for theses servos?

Tintin · 08-10-2006, 03:40 AM

Tower says: Power Supply: 4.8V (Futaba does not recommend using 6V)

However I wonder, a 4.8 volt/4 cell NiCd/NiMh pack can deliver quite a bit more freshly charged. Do they mean they don't recommend using a 6V/5 cell rx pack.

I use 5.8 volts for the servos (9252's) thru the Fromeco/Arizona reg in my Titan which works like a charm.

R-4-L · 08-10-2006, 05:31 AM

fully charged 4.8v pack reaches 6v, i'v been using a regulator with 5.6v output with no issues, but keep watching this thread im sure there are ppl who used 6v on them.

BarracudaHockey · 08-10-2006, 06:21 AM

Regulated will be fine, they mean don't use a 5 cell pack.

Mike C · 08-12-2006, 07:48 AM

I've been running them on 6 volt through a Fromeco Reg for the past 6 months with no problems.

08-10-2006, 03:05 AM	#1 (permalink)
helis101 Registered Users My HF Map location Join Date: May 2006	Can i run futaba s9252 for cyclic on 6volts I have the new rex 600 i was wondering i can run s9252 for cyclic on 6volts? Will the bec witch has an 5.9 volt out put work for these servos or will i fry the servos? or do i have to get 6volt regulators for theses servos? __________________ Jeff

08-10-2006, 06:21 AM	#4 (permalink)
BarracudaHockey Registered Users My HF Map location Join Date: Jan 2005	Regulated will be fine, they mean don't use a 5 cell pack. __________________ Andy AMA 77227 Jacksonville FL http://www.jaxrc.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

08-10-2006, 03:40 AM	#2 (permalink)
Tintin Join Date: May 2006	Tower says: Power Supply: 4.8V (Futaba does not recommend using 6V) However I wonder, a 4.8 volt/4 cell NiCd/NiMh pack can deliver quite a bit more freshly charged. Do they mean they don't recommend using a 6V/5 cell rx pack. I use 5.8 volts for the servos (9252's) thru the Fromeco/Arizona reg in my Titan which works like a charm.

08-10-2006, 05:31 AM	#3 (permalink)
R-4-L Registered Users My HF Map location Join Date: Apr 2005	fully charged 4.8v pack reaches 6v, i'v been using a regulator with 5.6v output with no issues, but keep watching this thread im sure there are ppl who used 6v on them.

08-12-2006, 07:48 AM	#5 (permalink)
Mike C Registered Users Join Date: May 2006	I've been running them on 6 volt through a Fromeco Reg for the past 6 months with no problems.

Register Now

Log-in