One way bearing on Avantgarde

[mejnertz]

Hi Beam dudes..
I destroyed my one way bearing on the Beam Avantgarde today, and wanted too put a new Owb in the autorotation case, but it had a loose fit and wouldn't stick in the case, do any of you know how to put this One way bearing into the case and make it stick??

My friend just tried to use green locktite, but it didn't hold

With kind regards
Benjamin

[Rotosmasher]

How hard was the old bearing to remove? Did the damage affect the case? Perhaps measure the outside diameter of both the old and new bearings as a starting point.

[w_prasit]

wait for a while ... Super BEAM E6 is coming
Thanks to BEAM deliverment team

[Yoda DK]

Originally Posted by w_prasit

wait for a while ... Super BEAM E6 is coming
Thanks to BEAM deliverment team

any info on that?

[Jamesppp]

Is anything missing???

[Yoda DK]

Originally Posted by Jamesppp

Is anything missing???

?? there is not anything missing. the owb case expands under load.causing the owb to spin in the case. thats the problem Benjamin and i is having. the owb case in alu is to soft and wenn doing 3d it just expands and makes the owb spinning. this causes the heli to loose power and crash

heard that Beam is comming with a new owb case. but i'm not sure

[w_prasit]

That's right !!!

Current oneway system will limit head speed not over than 2300 RPM, over than that oneway cannot resist if you fly hard 3D. but New oneway system will make BEAM E6 run on 2500 RPM without any issue. It will arrive to me on next week, I will show you soon

2300 RPM with stock BEAM E6, it also very good heli class 600 but for pilots who love high RPM, it's not enough. They want more RPM so BEAM engineer team develop new oneway to serve this target group.


Thanks to BEAM Team and Welcome you to Super BEAM E6 !!!

[audio131]

my assembly that came in my kit was red. i see the replacement online is silver,,is that the better one?