Register Now

coldpilot · 07-11-2013, 02:44 AM

Just received the Pyro 800-40 and a Kosmik 200. the motor leads appear to be 2 winding wires soldered together.on each leg with red, green and blue sheathing .Is this normal? this is my first experience with the Pyro motors. Do I solder the bullets on the end of these like normal? It seems they would swim in the 7 mm bullets.
Any advice appreciated.
Cheers

Vinger · 07-11-2013, 03:11 AM

All normal and 7mm bullets is OK as well, but you can go down to 6mm or even 5mm it will make no difference, even better is to solder the bolt on lugs directly to the motor if you don't need long leads.

coldpilot · 07-11-2013, 09:58 AM

Thanks Vinger

07-11-2013, 02:44 AM	#1 (permalink)
coldpilot Registered Users Join Date: Apr 2011	Pyro 400 motor leads Just received the Pyro 800-40 and a Kosmik 200. the motor leads appear to be 2 winding wires soldered together.on each leg with red, green and blue sheathing .Is this normal? this is my first experience with the Pyro motors. Do I solder the bullets on the end of these like normal? It seems they would swim in the 7 mm bullets. Any advice appreciated. Cheers

07-11-2013, 03:11 AM	#2 (permalink)
Vinger Registered Users My HF Map location Join Date: Sep 2007	All normal and 7mm bullets is OK as well, but you can go down to 6mm or even 5mm it will make no difference, even better is to solder the bolt on lugs directly to the motor if you don't need long leads. __________________ Henseleit TDR, TDR2, TDF, TDS, TDSF Kontronik, Scorpion ESC, iChargers, VBar, VControl Old hand at Planks Peter

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-11-2013, 09:58 AM	#3 (permalink)
coldpilot Registered Users Thread Starter Join Date: Apr 2011	Thanks Vinger

Register Now

Log-in