Clutch bell removal trick

[u8at711]

How are u guys getting the starter shaft and clutch bell apart ?

So far, I removed both grub screws, and started using a spring loaded punch down the center of the start shaft coupling, got it about 3-4mm apart. Was going to pull the mount block out and toss the whole thing in the trash, and rob it from that 2nd NIB kit I have.
But would really like to get this apart.

Had to walk away for a break, headed to the middle school to shoot off some rockets with the kiddies !

[u8at711]

Ok it's out,

I used a pre-loaded center punch, removed center punch tip, inserted a small thin metal shaft in punch and got it apart,
Looks like the adaptor spun on the shaft causing burrs during a fuel locked situation.