Register Now

Inat90degrees · 12-08-2014, 01:23 PM

Please disregard. I got my sister who reads on a 3rd grade level to read the instructions to me and found that you do use the original parts!

I just purchase a Microheli main rotor package and it didn't come with the feathering shaft and parts. Do I use all stock feathering shaft and parts to connect the blade grips to the main rotor hub? Tighten about as tight as a stock set up? Thanks

d12bn · 12-08-2014, 08:19 PM

Your sister is correct . Shoot me a message if you have more questions

Dragonsbreath · 12-08-2014, 11:02 PM

What I found out when I ordered the Microheli cnc swash and head assembly is that it did not come with a feathering shaft but the stock one will work, I got an extra one anyway since the one in the stock head is still good. And I also was told by the LHS and Microheli is that the stock dog bones will fit. Now the sad part, the LHS said that delivery of parts are running a week longer cause of the holidays, just my luck. Hope this helps a little.

Dave

12-08-2014, 01:23 PM	#1 (permalink)
Inat90degrees Registered Users Join Date: May 2013	Microheli CNC DFC Main Rotor package Please disregard. I got my sister who reads on a 3rd grade level to read the instructions to me and found that you do use the original parts! I just purchase a Microheli main rotor package and it didn't come with the feathering shaft and parts. Do I use all stock feathering shaft and parts to connect the blade grips to the main rotor hub? Tighten about as tight as a stock set up? Thanks

12-08-2014, 08:19 PM	#2 (permalink)
d12bn Registered Users Join Date: Jun 2011	Your sister is correct . Shoot me a message if you have more questions __________________ Team Scorpion Team Boca Bearing Team Revolectrix Check out my Heli Pilot Shirts https://teespring.com/stores/rc-heli-pilot-shirtsMy Youtube channel http://www.youtube.com/user/JJInvert...n?feature=mhee

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-08-2014, 11:02 PM	#3 (permalink)
Dragonsbreath Registered Users Join Date: Oct 2013	What I found out when I ordered the Microheli cnc swash and head assembly is that it did not come with a feathering shaft but the stock one will work, I got an extra one anyway since the one in the stock head is still good. And I also was told by the LHS and Microheli is that the stock dog bones will fit. Now the sad part, the LHS said that delivery of parts are running a week longer cause of the holidays, just my luck. Hope this helps a little. Dave

Register Now

Log-in