Quark isssue

[mike71]

Helping on a setup
Trex 450 V2 stock motor and esc align servos
Spartan Quark with 5084
DX8
Ok so went though setup and hover it and everything going fine then slams to ground the lights on the rx were blinking with a red light in there. I seem to be lost bind so I fought this for a bit and same thing keeps happening.
Then I tried a DX7 and went though a battery seemed to work fine then on the second battery same thing losing bind. So this time I put it on the bench it was going though its glitching and looking for signal I unplugged the gyro and the signal came back.
Any ideas whats going on

[chargh]

Sounds like maybe a brown out. With the blades off (both main and tail) try moving the sticks all around real fast so the servos get a good workout. Does this cause a glitch? If so you may be pulling to many amps for your bec.

Sent from my HTC One V using Tapatalk

[frito169]

any pics? I had the same issue and it ended up being noise from the motor affecting the satellite. I moved the satellite further away from the motor and voila everything was fine.