Tail motor bad?

[SQRT(-2)]

Hi, I tried the stock brushless tail, but now I am having to give the heli a lot of right rudder to fly. I am trying to adjust settings to see if I can tweak it out. I shall try new main blades when I can get them. If I decrease pitch it won't fly. I have noticed a slight wobble when running. This is basically invisible when the motor is stationary, but you can notice the wobble when it is running. Is some of this OK? or does this mean the motor is basically shot and I should have got the 2.9g in the first place? I have crashed a lot, and the tail rotor/outrunner have popped out innumerable times.

[mikejbb]

I like the 2.9g tail. It holds well. I crashed a few times and the tail motor finally holder broke off and ripped off the wires and I rewound it and am now it's just like new. First rewind and it worked! I also lost the "c" clamp holding on the rotating part and fly without it and now I just lost the 2nd bearing and fly just fine without it too. I have a 2nd 2.9 that I'll put on when this one fails and then I'll just rewind it again if needed.

[Dusty1000]

+1 for the 2.9g tail motor, it's night and day compared to the stock brushed motor

Dusty