START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
300CFX Blade 300CFX Helicopters Information and Help |
|
LinkBack | Thread Tools | Display Modes |
03-28-2015, 09:29 PM | #1 (permalink) |
Registered Users
Join Date: Jul 2014
|
Talon 35 Setup for Stock Motor?
Guys I could use some help. I am rebuilding and upgraded the speed control what should my settings be?
|
Sponsored Links | |||
Advertisement |
|
03-29-2015, 08:00 AM | #2 (permalink) |
Registered Users
Thread Starter
Join Date: Jul 2014
|
I do not want to run in Governor Mode. Trying to give you guys as much info as I can.
|
03-29-2015, 09:15 AM | #3 (permalink) |
Registered Users
Join Date: Feb 2013
|
Just go with helicopter and fixed end points on the throttle tab.
Brake will be disabled. On the cutoffs tab leave all that at factory. For the motor tab you can also leave all that to factory unless you get your motor wires backwards and don't want to unplug them you can reverse the motor there. Leave the other tab default too. First time you power the heli up: * before plugging the heli in set a 0-50-50-50-50-100 curve. * set throttle travel adjust in your tx to both 60% for high and low * throttle hold off collective stick high plug in heli. Raise the 60% in travel adjust a few % at a time till you get a sound off, mine are around 110-130% but yours may vary so go slow. * Drop collective all the way and there will be another sound off. * Start raising the throttle travel % till you get another sound off. My vary from 85-120% here so again go slow. After doing all that your motor is armed and ready to spool up.
__________________
Team MSH USA - Cyclone Blades MSH Prôtos 380 Brain 2 MSH Prôtos Max V2 Brain |
Thread Tools | |
Display Modes | |
|
|