Wrong Signal in Thro ?

[bib60]

Hi
My Naza H see the input throttle signal positive, but in reality, it is négative, the ESC see it négative too, the radio send negative too.
Is it a bug from Naza H ?
From my FrSky X8R ?
I'm lost ;-)

[macarey]

No, think this is standard, something to do with differences between Futaba & Spectrum transmitters I think.

Mine goes wrong way to, however all works fine.

I always test everything first with ALL blades off and make sure everything seems to be spooling up correctly and then making sure no unexplained jerks in swashplate when I change mode.

[StripedGear]

If your throttle is working correctly then don't worry about it... But I would consider bypassing the naza throttle control if I were you... It's very simple... just remove the jumper lead from the Naza throttle port to the RX throttle port completely... and plug the speed controller throttle lead back into the RX throttle port as normal.....

[wearman]

Can you do this without removing the red wire? I use the NAZA H BEC, so will i be powering it twice?

[StripedGear]

you don't want 2 power sources.. pull the red wire.