3dx head diagram trex/vibe

[dondrake]

here are diagrams for proper installation.

[dondrake]

heres a pic or 3 installed

[oldschool269]

do you think that will fit on a vibe 90 10mm main shaft >?
and swing 710's ok ?

jason

[dondrake]

Hmmm I just put a caliper on my main shaft, and its 10mm. I would only be concerned for feathering shaft I guess. Reason being its from a vibe 50 and I'm dont know if the 90 needs a stronger shaft.

[3DX!]

It may, not sure, you will have to drill 5mm holes on the blade holder in steed of 4mm that may be it.

Do you know the diameter of the spindle of the vibe 90????

[oldschool269]

NO not off hand , i will have toi pull the spindle out and measure it ..


is this head made of t6061 ?? any issues with swinging 710's on the grips ??

many many thanks
Jason

[3DX!]

Originally Posted by oldschool269

NO not off hand , i will have toi pull the spindle out and measure it ..


is this head made of t6061 ?? any issues with swinging 710's on the grips ??

many many thanks
Jason

Hello Jason!

Yes they are made out of 6061, if you use Radix 690´s or 710´s or any other that feet on a 12mm blade holder, as I mention you will only need to enlarge the holes to 5mm.

I have never tried spinning 710´s; the head looks strong so it "may" handle them.

I know some are planning to use the 3DX 600/Vibe 50 Head on a Mikado 700 conversion using 710´s. They also have 10mm main shaft.