START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
nano CP X Brushless Mods Blade nano CP X Brushless Mods Information and Help |
|
LinkBack | Thread Tools | Display Modes |
05-10-2014, 05:25 PM | #1 (permalink) |
Registered Users
Join Date: Dec 2013
Location: San Francisco, CA
|
Finally pulled it off
Hi all,
No questions this time, just here to celebrate! After 5 failed attempts over like 3-4 months I have finally pulled off a double BL conversion. I started with virtually no soldering ability, and after all of this I can quickly solder tiny joints that I couldn't imagine doing months ago! The first attempts were incredibly messy and all of the bad joints kept the thing from ever flying. It isn't perfect, but I finished this time feeling proud, and sure enough it flies like a dream! Time to pop the champagne. Anyway, here's the pic!
__________________
Protos380 | Oxy2 | OMP m1 | nanoCPX BL |
Sponsored Links | |||
Advertisement |
|
05-10-2014, 05:30 PM | #2 (permalink) |
Registered Users
Join Date: Jan 2014
|
Good job on learning new skill. What is the esc you use? What tail motor. What main motor?
|
05-10-2014, 05:34 PM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: Dec 2013
Location: San Francisco, CA
|
Two XP-3As, one driving the HP03SE 13500KV (mild) and the tail is a HP02T 12000 KV.
Though I didn't buy from Astroid because they were sold out, BIG thank you to Dylan, as without the instructions on his page this wouldn't be possible!!
__________________
Protos380 | Oxy2 | OMP m1 | nanoCPX BL |
Thread Tools | |
Display Modes | |
|
|