480 xxtreme Main Shaft

[pgleesonuk]

Can some one tell me the length of the 480 main shaft, and if it has holes at both ends.

Like this picture.

Thanks

[pgleesonuk]

Having just found a build picture showing the hole is further up on one end.
Can some one also tell me the distance from this hole to the end of the shaft

The distance between the hole is what I'm interested in.

many thanks

[_Kyle_]

I don't know what the distance is but when you install make sure groove is on the bottom

[Mentalic]

Originally Posted by _Kyle_

I don't know what the distance is but when you install make sure groove is on the bottom

+1
Snap ring grove to the bottom!

[pgleesonuk]

Sorry you may have mis understood.

I have a logo 400SE, and I want to upgrade the head to a single yoke, as in the 550SX or 480.

So I need to know the distance between the holes, or at least an idea.

If someone can measure the height between the jesus bolt and the centre of the tail drive pulley that would be great.

Thanks

[Mentalic]

Originally Posted by pgleesonuk

Sorry you may have mis understood.

I have a logo 400SE, and I want to upgrade the head to a single yoke, as in the 550SX or 480.

So I need to know the distance between the holes, or at least an idea.

If someone can measure the height between the jesus bolt and the centre of the tail drive pulley that would be great.

Thanks

Ok I get it now. For what its worth I checked my spare Logo 480 shaft and the belt drive pin to head bolt is 138mm on center.

Picture of the part:
http://shop.mikadousa.com/04817-Main...480_p_750.html

[pgleesonuk]

Originally Posted by Mentalic

Ok I get it now. For what its worth I checked my spare Logo 480 shaft and the belt drive pin to head bolt is 138mm on center.

Picture of the part:
http://shop.mikadousa.com/04817-Main...480_p_750.html

Thanks very much