will this Roxxy motor work on a Protos?

[kavic5150]

http://www.robbe.de/roxxy-bl-outrunn..._from_store=de

Its technically an airplane motor with 14 poles but on 6s it would be within the posted commutation (max RPM) limits of YGE and Castle escs.

Heres its specs since they dont seem to show up on the website.

Specifications:
Idle speed: 1000 rpm / V
Voltage: 10-20 volts
LI_PO: 3-5
No-load current: 3.30 A
Open circuit voltage: 7.40 V
Full load current: 80.00 A
Voltage: 14.80 V
Case diameter: 42.00 mm
Length: 50 mm
Shaft diameter: 5 mm
Thrust max. 3,250 grams
Total weight with cable and adapter: 195 g
Propeller Size: 13 x 6.5 ING

[flint723]

It's pretty close the max diameter you could run but looks like it would work fine. With a 13t pinion you'd have head speeds close to stock 880kv with 15t pinion.

[isogloss3d]

The specs rate it at 5S max and the voltage range corresponds with that as well. You could push it to 6S and take your chances?

[kavic5150]

This site says 80 amps max. Not sure if its accurate or not.

http://www.hoelleinshop.com/All-for-...=16377&p=16377