Wild BLheli Oversky 16600 problems

[Tattoonick]

https://vimeo.com/105715448
So I've read up on how to properly bind and arm this thing, bought it used from a member on here. He said it ran fine for him, but when I put it into stunt mode it starts doing this pulsing thing. Any ideas what I could be doing wrong that makes it do this?

[Webss]

My nano was doing that because of bad batteries.

[Tattoonick]

Originally Posted by Webss

My nano was doing that because of bad batteries.

I double check that today when I get home, but Im pretty sure that was a fresh battery.
Unless a 180mAh 45C battery isn't enough juice for that motor, though I would assume it is.

[NCcraig]

I have seen a bad solder joint, either on a battery connector or an ESC, cause that problem before.

[Tattoonick]

Originally Posted by NCcraig

I have seen a bad solder joint, either on a battery connector or an ESC, cause that problem before.

Are we local? Do you do paid analysis, diagnostics and repair?

[NCcraig]

Originally Posted by Tattoonick

Are we local? Do you do paid analysis, diagnostics and repair?

No and not anymore.

[Guapo131]

Originally Posted by Tattoonick

Are we local? Do you do paid analysis, diagnostics and repair?

diagnostics and repair: Check out Mega Micros. They fix stuff like this all the time. http://www.megasmicros.com/product_p/repair-all.htm

[Tattoonick]

Originally Posted by guapo131

diagnostics and repair: Check out Mega Micros. They fix stuff like this all the time. http://www.megasmicros.com/product_p/repair-all.htm

Cool, I might look into that. Thanks!

[Tattoonick]

Originally Posted by Webss

My nano was doing that because of bad batteries.

Welp, plugged in a battery fresh off the charger and put it in Idle Up and ran smooth as butter. Guess that was it!