Register Now

Skycommander · 12-25-2012, 11:15 AM

Hi,
I had in place a futaba 9257 servo and decided to use it instead of the stock one but
I've tried every combination of gain adjustment I could think of and always end up with tail wag left right. On the other hand the 9257 is working perfect on my 450X. Has anyone manage to setup the futaba 9257 with the 300x?

Marry Xmas to all heli freaks!

petedee · 12-25-2012, 02:56 PM

Shorten the arm a mm or two, when I swapped to a very fast servo on the tail I went down by about 1 mm and also dropped the gain to 45, perfect now, that was for a very fast servo, the Futaba 9257 is not so fast, also make sure you redo your endpoints.

12-25-2012, 11:15 AM	#1 (permalink)
Skycommander Registered Users Join Date: Jan 2009	Futaba 9257 tail servo wag with 300X Hi, I had in place a futaba 9257 servo and decided to use it instead of the stock one but I've tried every combination of gain adjustment I could think of and always end up with tail wag left right. On the other hand the 9257 is working perfect on my 450X. Has anyone manage to setup the futaba 9257 with the 300x? Marry Xmas to all heli freaks! Last edited by Skycommander; 12-25-2012 at 12:35 PM..

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-25-2012, 02:56 PM	#2 (permalink)
petedee Registered Users Join Date: Sep 2011	Shorten the arm a mm or two, when I swapped to a very fast servo on the tail I went down by about 1 mm and also dropped the gain to 45, perfect now, that was for a very fast servo, the Futaba 9257 is not so fast, also make sure you redo your endpoints.

Register Now

Log-in