Lama V4 Controls Problem

[nomad119911]

I haven't worked on my lama v4 for a while and a few days again I thought I would give it a spin and finding it nearly impossible to control. I took a closer look at the servos and I discovered the servos were not responding correctly to my commands.

The controls were rotated by 45 degrees counter clock wise on the remote. So for example if I want to pitch forward I have to move my control to the front and left.

If I want to roll right I would have to do forward and right, here is a picture of what I'm talking about

I tried searching for answers but most of them are mechanical. I have tried other servos and have experienced the same behavior so its not the servo. I was just wondering if there is anyone who can help me with this problem.
There is a chance that I could banged up the 4in1 in a crash and I might be out of luck there.

Thanks,

[Jotto]

I have the same problem on an Art-Tech Angel 300. Did you figure out what the problem was?