esc / RX tray `

[Alignnitro]

In the manual on page 1 , it states there is an Electronics Plate to be mounted on the side and I can not seem to find this part. Is this part metal , Carbon and maybe what bag it is suppose to be in.. Thanks so much

[vteknical]

It's plastic. Not sure what bag it came in as I was in bag opening frenzy when I built mine. If you don't have them and would like to use them let me know I'll be happy to send you mine.

[Alignnitro]

Thank you so very much for your offer of kindness... I found it inside the tail bag this morning.. I would have never expected to be there so I did not open and go threw it, I just looked and I must have overlooked it... Thanks again

[caralmar]

Glad u found it... However, they are not very useful because anything you mount on it has to be very thin or the canopy will not fit. I used one to mount a satellite.

[Alignnitro]

Yeah canopy seems to be tight from what I gather. I'm hoping to get my 6203 rx under it :-)

[vteknical]

Originally Posted by Alignnitro

Thank you so very much for your offer of kindness... I found it inside the tail bag this morning.. I would have never expected to be there so I did not open and go threw it, I just looked and I must have overlooked it... Thanks again

Your welcome. As Carlos mentioned it's reeeeaaally tight underneath that canopy. What other electronics are you planning on using?

[tauscnc]

I did not use those either, just double side tape the stuff on.


tauseef