New 300x thottle hold issue?

[Sheff_Flyer]

Hi all,

I have just bought a 300x, not had chance to fly it yet due to bad weather. I have bound it to my dx6i though and given it a quick checkover. If I initialize the heli with throttle hold engaged on my dx6i, the heli will always be stuck on idle up when I disengage throttle hold, regardless of my idle switch position. Is this normal? If I initialize the heli without throttle hold engaged all switches work as normal. Thanks

[ahahn]

You need to follow EXACTLY the TH throttle curves shown in the manual for the DX6i. Yes, 10%.

This is (likelihood 99.99%) the source of your problem.

[InFocus]

+1000 to ahahn.. That is the exact symptom you will get if the DX6i is not set at 10% on TH.

After you set the DX6i to 10% at TH (as specified in the manual), ensure there are no trim (should be at cener) or subtrim (should be 0) on the throttle, and then re-bind..

[Sheff_Flyer]

Thanks ever so much guys, that did indeed solve it. I thought I had done my settings by the book it was a stupid mistake but thanks for pointing it out!!