Power lab 6 need help

[Flying 3d]

Had this charger a lil over 2 months and today was my 1st time trying charging all my batteries on the mpa board and it keeps saying svs system reset. Which saying check supply wiring and everything is perfect don't know why keeps saying this. But my other charger working perfect charging batteries at the moment. Purchased this one a lot people say it's good but now I'm wondering that. Batteries are 6s 5000mah. Thanks for any help

[NSFlyer12]

Opps! See below.

[NSFlyer12]

Did you do the setup for the MPA board?

http://revolectrix.com/videos.htm?videoid=43

[Flying 3d]

Yes did all that still says it. Just checked to make sure all my connections are good.

[NSFlyer12]

Hopefully someone else will chime in to help you. Hope its not a bad board.

[Gregor99]

Originally Posted by Flying 3d

it keeps saying svs system reset.

Can you describe your power supply and all the wiring between the supply and the charger including any adapters, extensions as well as how the wires are connected to the supply?

[Flying 3d]

My supply is from solid hobby and power connection is a ec5.

[Gregor99]

Its it this one that comes an EC5? http://www.solidhobby.com/Power24-EC...pply_p_14.html

Or is a different one? Are there any adapters between the charger and the power supply? Do you have another power supply you can test with?

[Flying 3d]

Gregor99 that is the one. Ec5 to ec5 from supply to charger. Then pos neg from mpa board to charger. And a set of white wires that come from mpa board to charger to taking that's for balancing or something. I hooked up just like the walk through some else above posted and still get same feed back on charger.

[Gregor99]

It would be good to test it with another power supply. At this point, its either the charger, the supply or the cabling. If you can test it with another supply that would help confirm that its the charger. If that is the case, it will need to be serviced. If the issue is actually the supply and you send it in for service, they won't be able to reproduce the failure. That can be frustrating on both sides.

You can use a car battery as a power source, just as a test. If the unit needs to be serviced, you can work through your dealer, or contact FMA in Maryland directly.

Email: support@revolectrix.com or phone: (301) 829-5533

[Flying 3d]

Ok so to hook up to my car the charger only has a ec5 plug. How would that work. Gonna contact them tomorrow. Thanks for all the help and I'll update see what they say.