TORQ servos

[stanley1]

hi all, just purchased 3 x BL9180's for cyclic and a BL9088 for the tail for my 600e pro build. Question is whats going to be a good 2s lipo to go for? i dont think space will be too much of a problem so maybe up to 2500mah its the C rating im concerned about, how much current do these draw? my setup will be AR7000 rx and a full size v bar to the servos. I was looking at thunder power 1900mah 2s 20c rx lipo but it had a current limitation of 3.5amps due to the size of the wire,what do you think? I diddnt get the 9188 as it was out of stock but thinking now maybe i should send that back and wait for the 9188? is it much better? one final question guys, Where can i find some decent metal servo arms that will fit these bad boys?

[heli]

I've been using the NRG 2S 2500 without any issues on an 8 Volt setup on my Fusion 50, I have been getting 3-4 flights. Typically I just charge after 3 anyway to avoid any issues.

[im4711]

I also use the 2500 mAh NRG. Works pretty good in that combination. I think almost anything about 2500 mAh should be fine.
1900 mAh seems a bit low. You will not get many flits that way.