CGY 750 v1.4

[budds1978]

Hey Guys Need Some More Help
In Basic Swash When I Go To Set Up Gyro Direction For Aileron and Elevator When I tilt Heli Movement Is Vey Fast And Very Little Almost Like The Travel Is To Little, Not Even An Eighth Inch ! It Does Appear To be Correct Is This Normal ? My Beastx Seems To Have Much More Noticeable Movement. I watched dchekas Video He Is getting A ton More Movement Than I Get !
Also On Rudder Servo Setting MKS 990 Set At 760 ? I Have 960s On Cyclic I set Them At DG 285 I don't Think The Setting Could Cause This To Happen Even If They Are Wrong, Even Though I Am Pretty Sure They're Right

Thanks,
John

[dchekas]

If you're referring to the gyro compensating when you move the Heli, it's normal for there to only be a slight amount of movement. I wouldn't sweat it, as long as it's compensating the right direction.

[budds1978]

The Movement is barely noticeable, In Your Video The swash Moves A lot Compared To mine. If You Blink You Would Miss It Mine Does Not Move A Tenth as Much As Your Swash does ! Is It Possible I Have Another Parameter Screwed Up ? If I Tilt Heli at the speed You Did In Video It Will Barely Move At All.
I Just watched Your Video Again For Basic Swash And My Settings Are Almost Identical To Yours
Sorry to Make You nuts, It Just Doesn't Seem Right
John

[budds1978]

When unit Initializes and Goes To main Screen All Gains Are 110 %
Can The Gain Settings Cause This ?
John

[dchekas]

That gain is far too high. Your initial gains should be 50%.

What radio are you using?

[budds1978]

Futaba 10CGH I Haven't Touched The Gains I Just Plugged It In And Updated To 1.4 And That's Where The Gains Ended Up After The Update ! And I don't Think My Transmitter Can Adjust Gains For Aileron & Elevator, Unless I Can Figure Out A Way To Assign Channels And Use End Points To Adjust. So Its Not Radio Issue. I Would Think Setup Menu Would Not Be Affected By Gain Setting, But I could Be Wrong
I Appreciate The Help, I'm Usually Pretty Good At This Stuff Been Doing It A Long Time And I Fix Cars For A Living , That's Why I Think Something Is Not On The Money ! Me Programming a Car Is Like You Programming a CGY750 !
I Own A Repair Shop Over In Mahopac.
I Will Lower Gains To 50% And See What Happens I Really Appreciate Your Time To Help Me Out. Thanks,

John

[ch47c]

Budds, I had the same thing on one of my units. When I was finished programming, I returned the cyclic to AVCS and the movements were more pronounced and compensating the wrong direction. The minute amounts were difficult to see.
I went into the Flight Tuning MAP and selected AVCS and the movement was more pronounced and in the incorrect direction for my heli, so I Reversed the AGy Dir and EGy Dir in the Swash Basic MAP.