START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Night Flying Night Flying Helis Info |
|
LinkBack | Thread Tools | Display Modes |
12-13-2007, 10:10 PM | #1 (permalink) |
|
2.4Ghz glitching
i recently changed my night setup on my trex 450 and notice some glitching. i was flying w/ an AR7000 rx w/ the align inverter powered by two cells off of my battery's balance tap. i only had one glow wire plugged in, the other lead was left unplugged.
i assumed that since my inverter was isolated from the rx via my ESC(align with the ferrite ring still on it) that running it off the balance tap would be ok. is it possible that this is not the case? or is having the other driver lead unused a problem? the glow wire was one of the angel hair sized wires that i soldered myself, could this be part of the problem? |
Sponsored Links | |||
Advertisement |
|
12-14-2007, 08:41 AM | #2 (permalink) |
Registered Users
|
The simple test is to unplug the inverter from the battery and try it again.
Try all of the combinations of wires plugged in. Since the RX and inverter are sharing a battery there is a possibility of noise getting to the RX through the power wires. I know that there are many running the same setup as you with no problems, you may have a bad or marginal part in your mix.
__________________
Jeff Borowski |
Thread Tools | |
Display Modes | |
|
|