Register Now

Modified · 12-01-2012, 09:42 AM

hey guys i just picked this up for my tail servo...whats the highest voltage i can run. I know its geared for 7.2 v or 2s lipo, however my kosmik BEC can go up to 8.3v. in comparison to the bls251 i have always used @6 volts...is it ok to go higher on this as well.

EO19 · 12-01-2012, 09:48 AM

I have my WR BEC set at 8.4v.

Dr.Ben · 12-16-2012, 10:19 AM

The Futaba HV servos are optimized to work on nominal lipo 2S voltage. Though there is nothing expressly forbidden about running them on the equivalent of a hot off charge 2S lipo voltage, my recommendation would be to run them around 7.4v. The new WR BEC's actually have this voltage range option.

Ben Minor

12-01-2012, 09:42 AM	#1 (permalink)
Modified Join Date: Feb 2012	256hv hey guys i just picked this up for my tail servo...whats the highest voltage i can run. I know its geared for 7.2 v or 2s lipo, however my kosmik BEC can go up to 8.3v. in comparison to the bls251 i have always used @6 volts...is it ok to go higher on this as well.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-01-2012, 09:48 AM	#2 (permalink)
EO19 Registered Users Join Date: Apr 2009	I have my WR BEC set at 8.4v.

12-16-2012, 10:19 AM	#3 (permalink)
Dr.Ben Registered Users Join Date: Apr 2004	The Futaba HV servos are optimized to work on nominal lipo 2S voltage. Though there is nothing expressly forbidden about running them on the equivalent of a hot off charge 2S lipo voltage, my recommendation would be to run them around 7.4v. The new WR BEC's actually have this voltage range option. Ben Minor

Register Now

Log-in