I've been a bad Protos owner...

[ryguy76]

Originally Posted by DoubleCH

I would think YEP/YGE comes default with governor off. Without governor store mode I wouldn't want to run governor mode because the normal governor mode with store spools up to full HS to see what the setup can do before slowing down to throttle signal/curve from the TX. Depending on your setting, spooling up to max achievable HS (regardless of your TX setting) may not be a good idea. I would just start with something reasonable as suggested, like 0 30 60 60 60 and go from there. Do not use linear throttle curvefor normal mode or else when you switch to idle-up mode you'll get a big jump in throttle value.

The instructions do say that the normal gov mode is ON from factory. I too, was surprised by this. I'll just wait for the card and setup gov store to be safe.

[ZeXx86]

For me normal governor in YGE was always very good. It spools HS very smoothly, no issue at all here. Also, for me both gov and gov store works identicly (and should work) except initial governor calibration. In gov store its done just first time.
If all is correctly configured there should'nt be any differences. Gov store gives you just more stable results with different batteries.
I fly YGE ESC for few years and I am very happy.
I just attached fan to it due to overheating issue.