Register Now

PC4CAB · 08-02-2011, 01:31 PM

Folks,

Can I use some of the Align electronics for a Logo 400? I have the following:

500-MX Motor
RCE-BL 70G ESC
DS 510 Digital Servo
DS 520 Digital Servo on the tail

Also, would the Align servos be a direct drop-in for the frame, or do I need to modify or purchase anything? (I know the Logo 400 comes with Futaba frames, so not sure if the Align servos would work?)

Heli will be used strictly to learn on - so lots of hovering and maybe a tad of forward flight, thats it...

Thanks in advance!

pgleesonuk · 08-02-2011, 02:36 PM

Servos yes, motor at 1600kv is Ok with a 16T pinion and 6S

PC4CAB · 08-02-2011, 02:40 PM

Great, thanks!

NovaCX12 · 08-02-2011, 03:51 PM

You'll need 2 sets of these, unless you have servo spacers already. The 510's will rub on the main shaft if you don't use some kind of spacer.

https://www.readyheli.com/H50057-Ser...0_p_33176.html

Bullfrog98 · 08-03-2011, 01:14 AM

My DS510 servos fit fine in my 400 frame with no spacers, although they do sit very close to the main shaft (but do not rub).

08-02-2011, 01:31 PM	#1 (permalink)
PC4CAB Registered Users Join Date: Jun 2011	Will This Work in a Logo 400? Folks, Can I use some of the Align electronics for a Logo 400? I have the following: 500-MX Motor RCE-BL 70G ESC DS 510 Digital Servo DS 520 Digital Servo on the tail Also, would the Align servos be a direct drop-in for the frame, or do I need to modify or purchase anything? (I know the Logo 400 comes with Futaba frames, so not sure if the Align servos would work?) Heli will be used strictly to learn on - so lots of hovering and maybe a tad of forward flight, thats it... Thanks in advance!

08-02-2011, 03:51 PM	#4 (permalink)
NovaCX12 Registered Users Join Date: Apr 2010	You'll need 2 sets of these, unless you have servo spacers already. The 510's will rub on the main shaft if you don't use some kind of spacer. https://www.readyheli.com/H50057-Ser...0_p_33176.html __________________ mCPX BL

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

08-02-2011, 02:36 PM	#2 (permalink)
pgleesonuk Registered Users Join Date: Sep 2009	Servos yes, motor at 1600kv is Ok with a 16T pinion and 6S

08-02-2011, 02:40 PM	#3 (permalink)
PC4CAB Registered Users Thread Starter Join Date: Jun 2011	Great, thanks!

08-03-2011, 01:14 AM	#5 (permalink)
Bullfrog98 Registered Users Join Date: May 2010	My DS510 servos fit fine in my 400 frame with no spacers, although they do sit very close to the main shaft (but do not rub).

Register Now

Log-in