Governor ESC Setup

[mdauth]

Just started flying heli's late this summer and the Fusion 50 was my first, while everyone is opting out I guess being new to this frame I am planing to fly it for a while longer, thanks to Flint I was able to get quit a few spare parts and extra frame so I'm good. Did experiment my first main gear stripping with the old molded black gear. I've install the cnc main gear now and being cautious, just want to make sure my ESC is well setup. I'm running the Ice2 120HV, Scorpion HK-4025-630kv with 12t pinion gear, 12s.
Thx, Mike

################################################## #####
# Castle Link Data File
# Created: Monday, September 15, 2014
# Do Not Edit This File By Hand
################################################## #####
Hex55: 85
Brake Delay: .6 sec (Delayed) (*)
Brake Ramp: Immediate (*)
Motor Start Power: Medium (59) (*)
Direction: Forward (*)
Brake Strength: 0%, Disabled (*)
Power-On Beep: Enabled (*)
Motor Timing: Normal (5) (*)
Data Log Enabled: 255
Current Limiting: Insensitive (180A)
Vehicle Type: Helicopter
Throttle Type: Governor Mode
Throttle Response: Medium (5) (*)
Governor Gain: 12
Initial Spool-Up Rate: Medium (5) (*)
Head Speed Change Rate: Medium (5) (*)
Auto Rotate Enabled: False
Governor Mode Type: Fixed
Vehicle Setup - Battery Type: LiPo
Vehicle Setup - Number of Cells: 12
Vehicle Setup - Battery Voltage: 44.4000
Vehicle Setup - Gear Ratio: 10.750
Vehicle Setup - Motor Kv: 630
Vehicle Setup - Motor Number of Poles: 8
Desired Head Speed 1: 2000
Desired Head Speed 2: 2100
Desired Head Speed 3: 2200
PWM Rate: 8 Khz
Sample Frequency: 1 Sample / Sec (*)
Cutoff Voltage: 40
Auto-Lipo Volts/Cell: 3.2 Volts/Cell (*)
Voltage Cutoff Type: Soft Cutoff (*)
Current Cutoff Type: Soft Cutoff (*)
Link Live Enable: Disabled (*)