RC Aerodyne AS-350 700 size

[cnchelicopter]

Ok fellas...I got a little ground mishap and my SuperScale RC Aerodyne AS-350 got a little damage but not bad at all. I just dont have the time to work on it and rather fly so I'm selling it as a whole..the values of each component probably worth the $ I'm asking for
What you will need to get flying again. Again, these are all RC Aerodyne stuff
1 - Main rotor head. This is the 3 blades version. Selling for about $113 on RC Aerodyne site...not too expensive
2 - Tail rotor (technically, only the shaft is bent but I'm not sure if you can get the shaft alone)
3 - A set of main blades (3 blades)
4 - A set of tail blades ( 2 blades)
5 - Servos arm for 3 KST servos. The arms were broken.

That is all you need to get flying. The accident happened on the ground as it tipped over. I think the MicrobeastX controller didn't initialize properly as I was too anxious to get flying and not do a complete check.

Other damages is more cosmetic as you will see in the picture, the landing skid got a little bent. Not a big deal. No crack or major damage to the fuse.

What comes with the heli

1 - Align 700BL 470kv motor
2 - MicrobeastX flybarless controller.
3 - RC Aerodyne super scale fuselage with cockpit
4 - Extremely detailed cockpit with navigation screen and sound. I will include the link to the cockpit

I'm asking $350 firm because if I were to sell each component separately I probably got more than what I'm asking, but I'm too lazy to part this beautiful helicopter, so for $350, you get all the top notch electronic and basically a free superscale RC Aerodyne fuse ($600 value) and Roban mechanic. By the way, since the main shaft is not damaged (bent), you can drop the new rotor head in like 5 min....a straight replacement. The same thing with the tailbox.

Obviously this thing is too big to ship so local pickup in Southern California only

Video link to cockpit

RC Aerodyne AS-350 cockpit (0 min 34 sec)

Updated with picture of parts needed to get it flying again...$225 to $258

[Cliff Chmiel]

if you decide to ship, let me know,

[mbutler6063]

checking to see if I can arrange a local pickup from our office in Riverside.
Should know tomorrow sometime

[mbutler6063]

PM sent

[mbutler6063]

No reply
I'm out