Trex 700 Nitro Pro Flybarless and CoPilot 2 Test Flight

[GeorgeFF]

Originally Posted by markespina

@pril
Thanks mate. It was drifting to the right but we fixed it easily using the SET ANGLES menu in the IRNET programmer.

@Night
All of this is possible through you my friend. Your willingness to share your knowledge benefits a lot of people. Many thanks! Many thanks!


@yacsf
Yes the CP2 goes in between the 3G and the RcRx.
It basically looks like this

SERVO ---->3G---->CP2---->RcRx

Because it was a 7 channel RcRx and the Trex 700N had a governor (which means all the channels were taken up) - I used the tail gyro gain channel for the 'ON/OFF' switch - pretty much as described in NightFlyr's sticky.

Did not use the RCV4.

Hope that helps you out.

Thanks for info i'll install it on my Trex 500 ESP FBL thanks again.

[GeorgeFF]

Hey , this is my Trex 500 esp flybarless with Fma Co-pilot II , flies and like a dream , setup was like @markespina said, SERVO - 3G - FMA CO-PILOT ll - RECEIVER and thats it.
Any question welcome.
Cualquier pregunta bienvenida.

Jorge.

[YOUTUBE][ame]http://www.youtube.com/watch?v=1Wp-x8qG4V4[/ame]