X50 Head build & Setup

[DaweMD]

Thanks YB and Bob. Will do and I appreciate the help.

[DaweMD]

What do you guy's recommend for throttle and tail servo's? What speed and torque for 6V?

[DaweMD]

I was thinking savox SH1290MG - Torque 70.8/5.10 Speed .05 6 Volts for the tail
Savox SC1257TG - Torque 138.8/9.99 Speed .07 6 Volts for the throttle
Your thoughts? I would like to keep all my servos the same name and I am looking to be able to run flybarless down the road and don't want to have to upgrade servos again. I believe these should be fast enough.

[DaweMD]

My cyclic servos are Savox SC1258TG Torque 166.07/12 Speed .08 @ 6V

[YBNORMAL]

I run a JR8900g on the throttle, it is overkill though. And a JRMP80g on the tail. The MP80g does not like even slightly high voltage though. I have it at 5.2 out of the AR7100 Rx and it will buzz a little at center stick at times. I am told this is ok and wont do this during flight. It still doesn't seem right though so I am thinking about an inline stepdown just to be safe.

Lots of opinions on speed for the throttle servo, I figured I would go for the gusto and put a fast tail servo on the throttle. I don't think you need anything as strong as what you quoted though for the throttle. Some say that the throttle should be faster than the cyclics so that the engine gets a head start on the main blades during hard pitch changes. But others say it doesn't matter.

Throttle:http://www.jrradios.com/Products/Def...odID=JRPS8900G
Tail:http://www.jrradios.com/Products/Def...odID=JRPSMP80G
Cyclics:http://www.jrradios.com/Products/Def...rodID=JRPS8717

YB

[Bob O]

I'm using a Torq 9080 on throttle, but only because I got a great deal on it. It was very lightly used. Also so I could run everything HV.

[DaweMD]

Once again, thanks for all the help guys.