 |
START HERE |
|
| Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
|
|
|
Unregistered
|
||||||
| Electric Motors, Gearing, Speed Controls, Gyros, Receivers, and Other Electronics Discussion Electric Motors, Gearing, Speed Controls, Gyros, Receivers and Other Electronics Discussion |
|
|
 |
|
|
LinkBack | Thread Tools | Display Modes |
10-26-2012, 07:02 AM
|
#1 (permalink) |
|
Registered Users
|
Futaba 9256 .. Will it not work on throttle channel?
Trying to install this servo on my throttle channel. But the thing just won't turn on till I go to full stick on my Tx.
If I put it on the tail channel on my beastx it turns on like a charm and works fine. ! But just not on throttle channel Of my rx or the governor. Same response turns on for like a second when I am at full stick to get to that extreme and then no power same while going down. CONFUSED! I thought one servo was bad. Tried two 9256 both straight on rx and governor they just don't work. Why? I am confused!!!!!!! Please help! Will align 620 work?
__________________
Goblin Gasser TRM VX310TT Align MJ Design DTS 700N 91 HZ-R 3D Blackout Extreme Gasser #4 MCPX BL 2 iX12 Gaba |
|
|
| Sponsored Links | |||
|
Advertisement |
|
||
|
10-28-2012, 05:01 AM
|
#2 (permalink) |
|
Registered Users
Join Date: Nov 2008
|
9256 is a tail servo that needs a 760us signal usually only generated by gyros and FBL units, so you can't use it for anything else unless you can adjust the rx output to 760us from its normal 1520us signal, which is not normally an option.
__________________
Trex 600N Pro with Vibe 50 Head and YS91RS motor, Vibe 50 VBar FBL, Trex744 VBar FBL MW44 Turbine, Logo 800 XXTreme, Logo 600 12s, Logo 500SE, Vario UH-1D (Building), Scratch built 625mm Quad. |
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
