Register Now

jayhawk25_2000 · 08-04-2007, 12:16 AM

Any suggestions on what my end points should be set at for the elevator and ailron for a sorta beginer like me. I have the tail set up and the gyro works good. It is just very touchy on the cyclic controls.

bclong21 · 08-16-2007, 09:56 PM

Try using about 20-25 on the expo. I would leave endpoints at no lower than 80 in case you need the throw to get you out of trouble.

08-04-2007, 12:16 AM	#1 (permalink)
jayhawk25_2000 Registered Users Join Date: Jul 2006	EPA for a newbie? Any suggestions on what my end points should be set at for the elevator and ailron for a sorta beginer like me. I have the tail set up and the gyro works good. It is just very touchy on the cyclic controls.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

08-16-2007, 09:56 PM	#2 (permalink)
bclong21 Registered Users My HF Map location Join Date: Dec 2006	Try using about 20-25 on the expo. I would leave endpoints at no lower than 80 in case you need the throw to get you out of trouble.

Register Now

Log-in