Help with Ufly Gyro settings

[Luigi Bella]

How do I setup the Gyro on my ufly?
I tried to improve how it was setup.........but I ended up messing it up(a lot!)
this is not the version with the 3-axis Gyro.

[ERRATIC]

What does it seem to be doing?

Steve

[magicmarty]

best way to prevent this again from happening is to use a fine tip marker and place a reference mark on the rx before you move the adjustment pot, that way you can easily go back to the factory default settings...remember the adjustment pot has a stopping point it does not rotate all the way around if you force it to do so it could damage it beyond repair...

[Luigi Bella]

When I take off it will start to drift (like usual) but when I correct it it does not respond about 10 seconds later it will over correct.

[magicmarty]

sounds like it could be your servo rudder link might be binding, check and make sure the linkage going to the tail is nice and easy to slide and no friction..if its binding the servo will try to move the tail pitch and it will stick and suddenly move which causes it to over correct..