Easiest way to remove maingear

[velocity90]

Hi,

I now it was pretty hard to install the main gear because of the 2 belts. Now I have to replace the oneway and before I start, any tips on what is the easiest way? I must be doing something wrong when installing the main gear because it's a real pain. :rolleyes:

[Raz0rSh4rp]

Pull the bolt.

Pull the one-way sleeve out between the skids.

Loosen your boom and push it in as far as you can.

Once you get the belt off it should slide right out.

It's almost impossible if you don't pull the one-way sleeve out.

[velocity90]

Originally Posted by SMarvin

Pull the bolt.

Pull the one-way sleeve out between the skids.

Loosen your boom and push it in as far as you can.

Once you get the belt off it should slide right out.

It's almost impossible if you don't pull the one-way sleeve out.

Thank you :rolleyes: maybe that's what I did wrong. Will try tomorrow

[maarset]

Wouldn't that be difficult with a mini tail servo? With the tail belt loose I just pull up the main shaft and slide out the whole main gear unit.

[Bob O]

I have a mini tail servo and that's the way I do it.

[maarset]

I'll have to try it. Thanks bob.

[Raz0rSh4rp]

I have a mini. It is a very difficult squeeze if you dont pull the one way sleeve.

Sent from my SCH-I535 using Tapatalk

[velocity90]

I have a mini and installing the main gear was a nightmare. Will look at the sleeve.