YGE 90 LV set up problem

[wipo]

I try to get the proper set up for this controller however in the full throttle position I get only instantly beebs.
In throttle low it starts according it should be and I can power up the electrical motor.
So my questions are:

Is it may be in programming mode and if so can I get rid of it?
I have done setting changes with programm card two.
To set it up I reduced the servo end points to 80 and at low throttle slowly turned it back till I heard the beebs at 107 %.

Trying to set the full throttle point it started already with instantly beeps at the 80 % servo end point.
But is there somebody who knows what it means continuous beeps without stop.
I am getting mad because I can power up the motor but it is probably not safe to fly it this way.

The motor is stock Scorpion in the Logo 550SX kit.
Settings are as recommended in the manual for this controller.

[DannyvG]

You are simply doing it wrong, or at least it seems you try to do it like a castle.
Set endpoints to 100%, full stick on startup then at some point (check manual) go to low stick. Then use progcard for the rest. Timing should probably be 18degrees.
Check the yge forum for more info

[buggyalstare1971]

Originally Posted by DannyvG

You are simply doing it wrong, or at least it seems you try to do it like a castle.
Set endpoints to 100%, full stick on startup then at some point (check manual) go to low stick. Then use progcard for the rest. Timing should probably be 18degrees.
Check the yge forum for more info

What do you mean full stick on start up? Can you please be more specific in the sequence of events your saying should happen. As I am very confused as well with these yge. I've watched video after video and have read so much over last 4 days.

[wipo]

Finally after long time struggling to set up this controller I get it working.
First of all I tried to reset the Fasst receiver in the Logo while powered on without succes.
Then I took another Fasst receiver and connected it to the YGE control card 2 to set up zero throttle and full throttle.
After this I connected the YGE 90-LV to the Fasst receiver in the Logo and at full throttle position I heard finally the 20 beebs and 2 OK beebs after powering it up.
Now I was able to adjust it in the Governer,Governer store or V-bar governer mode.
All according the description in the manual.
It still is a mistery to me but I made the maiden flight last saturday.
Actually I had send the YGE already back to Austria where I bought the Logo kit but I was lucky that the post office send it accidently back to my home so I was able to do some more tests with good results.
I learn every day again and again!
But this was very tricky.

[newbheliusr]

You ain't seen nothing yet. Lol.


Sent from my iPhone using Tapatalk