Register Now

lordw0rm · 04-24-2014, 05:47 AM

Are ball A same lenght ?

On my 550 dfc ( the last one with 730mx) on tail servo I have a problem.

Ball A is not safetely closed with the nut ( only little touch) using standard plastic servo arm.
Should I use a longer one ? Which one ?

thx

jsbach#1 · 04-24-2014, 06:31 AM

I have the same problem. I just sand down the servo horn a little bit to have enough for the nut to grab and use loctite.

Revenant759 · 04-24-2014, 09:59 AM

Same problem as well. I opted to thread it in good with CA acting as locktite. I was hesitant to cut/sand down the horn. I'm probably going to remove it and do that though. I really don't like it not being nut-secured.

04-24-2014, 05:47 AM	#1 (permalink)
lordw0rm Registered Users Join Date: May 2012	H55061 and HN6052 Tail servo linkage ball problem Are ball A same lenght ? On my 550 dfc ( the last one with 730mx) on tail servo I have a problem. Ball A is not safetely closed with the nut ( only little touch) using standard plastic servo arm. Should I use a longer one ? Which one ? thx

04-24-2014, 09:59 AM	#3 (permalink)
Revenant759 Registered Users Join Date: Sep 2013	Same problem as well. I opted to thread it in good with CA acting as locktite. I was hesitant to cut/sand down the horn. I'm probably going to remove it and do that though. I really don't like it not being nut-secured. __________________ Nano CPx BL -- T-Rex 150 -- 300x Mini vBar -- T-Rex 450 Pro V2 3GX -- Gaui X3 Brain -- T-Rex 550E Pro iKon

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-24-2014, 06:31 AM	#2 (permalink)
jsbach#1 Registered Users Join Date: Nov 2013	I have the same problem. I just sand down the servo horn a little bit to have enough for the nut to grab and use loctite.

Register Now

Log-in