Blade nano cpx

[alba_84]

Hi guys im very new to rc helis I have a walkera v400d02 and also just purchased a blade nano cpx. Ive been trying to learn on my blade im struggling with it at the moment, it will start as per usual but then just cut out with no led on but you can still see and hear the servos doing there thing any suggestions on what I should do? Sorry im so fresh im not up with the terminology.

Sent from my GT-I9295 using Tapatalk

[mike_a]

You may be better off posting this on the Blade nanoCPX forum.

[thepainter]

I had the same problem with mine but it was not when it was new it was just the other day, check and make sure all the plugs are properly seated in the board also check the battery connection. Im not really sure what it was on mine but I checked all the pkigs and put a freshly charged battery in it. I know thay lots of times if a battery is low that it will do this. Tey charging up the batteries and keep fresh batteries in your charger. If worst comes tonworse it could be the esc. The best place to get one cheap is rock bottom rc on ebay. Hope this helps.

[FlyBri3]

I haven't checked my wiring but when my batteries are going bad mine does the same thing. with a good fully charged battery it works fine.

[Neunerball]

Originally Posted by thepainter

I had the same problem with mine but it was not when it was new it was just the other day, check and make sure all the plugs are properly seated in the board also check the battery connection. Im not really sure what it was on mine but I checked all the pkigs and put a freshly charged battery in it. I know thay lots of times if a battery is low that it will do this. Tey charging up the batteries and keep fresh batteries in your charger. If worst comes tonworse it could be the esc. The best place to get one cheap is rock bottom rc on ebay. Hope this helps.

You ought to read https://www.helifreak.com/showthread.php?t=336421