START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Gryphon Electronics Gryphon Electronics Factory Support Forum |
|
LinkBack | Thread Tools | Display Modes |
02-22-2013, 08:46 AM | #1 (permalink) |
Registered Users
|
Gryphon 75V 20A Hyper HV BEC (GSR-7075LMT) as a Nitro BEC.
I happen to have one of these and the Pin Flag switch. I am thinking about putting it on my N5c to give me a On/Off switch capacity so I don't have to remove the canopy after every flight. I know I can get 4-6 flights out of one of my packs, would be nice to NOT have to take the canopy off when I am flying back to back.
The question I have it this: The specs for the BEC say 3-14s input voltage. My RX pack is a 2s 2550mAh lipo. Is this 3-14s a recommended minimum or will the unit not work correctly on a 2s lipo? I guess I can run a 3s 2200 but would rather keep the weight down. I have HV servos so this is a very expensive switch I know, but I already have it gathering dust from another failed project.
__________________
Synergy Factory Specialist / Rail Blades / Team Scorpion |
Sponsored Links | |||
Advertisement |
|
02-22-2013, 06:26 PM | #2 (permalink) |
Registered Users
Thread Starter
|
Gryphon 75V 20A Hyper HV BEC (GSR-7075LMT) as a Nitro BEC.
Never mind. Just made my own switch with 14 gauge wire and two power leads for amp load. Much cheaper than the gryphon.
__________________
Synergy Factory Specialist / Rail Blades / Team Scorpion |
Thread Tools | |
Display Modes | |
|
|